Creating Orac 2.0 patches on Nebulae via HDMI

Hello, I’m just trying to set up my Nebulae to work with Orac 2.0, but I can’t figure out how to remote client. I was wondering if anyone knew how to use HDMI from the Nebulae and what the username/password would be? I’m totally new to coding but I can usually figure out simple instructions. Thanks in advance for any help!

probably better posting on the MW thread, as this is not about the organelle.

short answer is… nebulae easiest solution is not to use hdmi, rather use my firmware (see MW topic), and then use ssh.
(though to install orac you dont even need to do that, it will install directly off usb drive)