Yes, here are instructions:
- Shut down the Organelle and remove power/batteries.
- Have a paper towel ready to wipe up any excess contact cleaner.
- Gently pull the encoder’s knob straight up to remove the knob.
- Place 2-3 drops of contact cleaner like Deoxit into the grove of the encoder shaft. This grove is shown in the photo below with the pink arrow.
- Once applied, rotate the knob 10-15 times in both directions and allow to sit for a few minutes. Then rotate 10-15 times in both directions again.
- Wipe up any excess contact cleaner from the encoder shaft and/or Organelle enclosure.
