what you should see is:
- start OTC_mother
- OLED say “running OTC” , modes : /usbdrive
- aux LED goes blue
- OLED blanks for about 10 seconds
- OLED shows some percentages with N/A against them , e.g. N/A 50%
(N/A is because the test mode doesn’t have cables for the knobs, unlike other modes)
(so, no you don’t move encoder again)
note: you should also see this, even if you do not have an HDMI cable attached… and this is worth testing,
if you don’t see the above, even when an HDMI is not attached, and you are using a ‘fresh SD card image’, then frankly, I cannot see how it can be anything other than different hardware revisions of the Organelle… as we are all using the same software, and the newer OTC_Installer checks the software, before installing it… so it cannot be corrupted.