HELP: Mic not turning off on Organelle-M in OS 5.1

Hi everyone,

I upgraded to OS 5.1 on my Organelle-m and now the mic switch is not turning off the mic when I switch to line in. Is there something I can look into with this? Could it be a hardware issue?

oh, somehow I used said to myself: “well, it is like that now” and didn’t think about asking for help or a patch in here, but yes, I have had the same problem. Once i turn the switch from ext int to mic, and then coming back to ext int, it is not coming back. it stays with the internal mic. I had to turn my organelle off and on a couple of times for it to work again as intended. good to know that i am not alone.

so, i guess (and hope) that it is a software problem.

Glad I am not alone. Maybe @chrisk or someone else can provide some insight.

On a fresh install of OS 5.1 on the Organelle M the switch appears to work…although that doesn’t mean it will stay working. Maybe something is disrupting, do you recall if it was working when 5.1 was first installed, then stopped, maybe after installing a patch or something?

@oweno Unfortunately, I don’t recall. Should I try another fresh install? Any testing steps you would recommend? Is it possible for a patch installation to even alter this?

From the web terminal you can run the “alsamixer” command:

This has a control for input selection (Input Mux). You can select Line In or Mic and normally you will see this change when flipping the switch on the back. You should also see some info printed in the console when you flip the switch. When the switch changes it issues one of these commands:

amixer set 'Input Mux' 'Line In'   # line
amixer set 'Input Mux' 'Mic'       # mic

So I don’t really know why it wouldn’t be working. It’s possible a patch or installer fiddles with the ALSA settings…

I see what one of the issues is. When I load up alsamixer, it sometimes shows my USB controller as the audio interface. For some reason, that seems to be overriding the internal sound card. Very strange.

That is strange. There can be more than one sound card, this will list them:

aplay -l

It is never clear what order the cards are in or how they are named, which has always made audio and MIDI configurations difficult. In alsamixer you can select a sound card by pressing F6. What controller are you using? Arturia?

It is a MPE wind controller, but midi only, no audio. It is Teensy based.